Scania XCOM 2.30 Diagnostic & Developer Tool - ECU Programming Software

Scania XCOM 2.30 is a diagnostic and developer tool designed for working with supported Scania vehicle electronic control units. It allows technicians to access ECU information, read diagnostic trouble codes, review parameters, and save supported controller data.

The software communicates with vehicle control systems through compatible VCI2 or VCI3 interfaces using the CAN communication protocol.

Supported Vehicle Control Systems

• EMS: Engine Management System
• GMS: Gearbox Management System
• RET: Retarder System
• AWD: All-Wheel Drive System
• CLS: Clutch Control System
• EEC: Exhaust Emission Control
• COO: Coordinator System
• BWS: Bodywork System

Supported Fault Code Categories

• EMS: S6, S7, S8
• GMS: OPC4, OPC5
• RET: RET1, RET2
• AWD: AWD1
• EEC: SCR1, EEC3
• COO: COO6, COO7
• HMS: HMS1

Diagnostic and Developer Functions

Depending on ECU type, vehicle configuration, software version, and access permissions, the tool may provide functions for:

• Reading and saving ECU information
• Viewing diagnostic trouble codes and parameters
• Reviewing vehicle and controller data
• ECU recovery and reset operations where supported
• Controller identification and configuration checks

Interface Requirements

A compatible Scania VCI2 or VCI3 communication interface is required for vehicle connection. Actual functionality depends on the connected hardware, ECU generation, software configuration, and vehicle application.